Revision History - Siemens XC1001-A Installation And Maintenance Manual

About this document
8
Building Technologies
Fire Safety

Revision history

Document no.
A6V10257473_e_en_--
A6V10257473_d_en_--
A6V10257473_c_en_--
A6V10257473_b_en_--
A6V10257473_a_en_--
Edition date Brief description
03.2015 - MP2.3 SR2
04.2012 - MP2.3 SR1
09.2010 - chap. 4.5 updated (fig. 5 and table)
- chap 7.2.1 added: method for calculation of the battery
capacity
- chap. 7.3: fig. 7.15 updated
- chap. 8 updated
- chap. 8.3: fig. 31 updated (loss of agent is normally
closed)
- chap 9.4 added: description of repeater display and
repeater terminal
- chap 12.1: procedure step 5 updated
- chap 12.2: country pre-settings updated
- chap 12.9: step 30 option 04 updated
- chap 12.18 added (step 60)
- chap 13.1 updated (paragraph number)
- chap 13.2 updated: warning for the calibration added
- chap 14.1 updated
- chap 14.2 updated (10s instead of 5s)
- chap. 15, 16, 17 updated: several wording
- chap 18 added
- chap. 19, 20 updated
- CE marking papers added at the end of the document
01/2010 Corrections after field tests:
- Chap. 3: Standards / 4.19 monitoring the status of
components (spelling mistake)
- Chap.4: fig 4 updated
- Chap. 6.3 label for XC1003-A is Pos. 8 not Pos.4
- Chap. 7.6.2 .... "to equipment outside" (spelling
mistake)
- Chap 7.8: 24V polarity output was wrong. 24V(+) is on
X5-3 and 24V(-) is on X5-4
- Chap. 8.2: note added for the connection of the 24V
power supply
- Chap 8.3: fig 31 modified: resistor 3.3k on RS485 line
removed
- Chap 11: fig 33 and 34 updated
- Chap 14.2: PMI picture is added on the top of the
description table, for an easier checking
- Chap. 16.2: access code for the alarm counter was
wrong
- Spelling mistakes
11/2009 First edition MP2.1
A6V10257473_e_en_--
2015-03-04