Siemens XC1001-A Installation And Maintenance Manual page 96

Connection to Sinteso / Cerberus PRO panels
96
Building Technologies
Fire Safety
b. activation delay: 3s
c. deactivation delay 0s
d. activation timeout: Enable / 3s
e. cause: Fire Control "XC10 Reset pulse 1" activated
f. effect: no effects
11. create a fire control named "XC10 Reset pulse 1+2"
a. formula: "- - - ALL OR - - -"
b. activation delay: 0s
c. deactivation delay 0s
d. activation timeout: Disabled
e. cause1: Fire Control "XC10 Reset pulse 1" activated
f. cause2: Fire Control "XC10 Reset pulse 2" activated
g. effect: assign to FDCIO OUT 1 (Relay A)
Create fire detection zones that trigger XC10:
12. under the section "Room Spirit 1", create an automatic zone named "Zone 1"
13. under the section "Room Spirit 1", create an automatic zone named "Zone 2"
14. under the fire control group "Training Center - Room Spirit 1", create a fire
control named "First alarm"
a. cause: "--- General autom. fire ALARM ---" assigned to section "Room
Spirit 1"
b. effect: assign to FDCIO OUT 3 (Relay C)
15. under the fire control group "Training Center - Room Spirit 1", create a fire
control named "Second alarm"
a. cause: --- General autom. fire ALARM --- assigned to section "Room
Spirit 1"
b. select Threshold = 2 (2 alarm events)
c. effect: assign to FDCIO OUT 4 (Relay D)
Assign XC10 zone "Block autom." output element:
16. under the fire control group "Training Center - Room Spirit 1", create a fire
control named "Block autom."
a. cause1: "All test modes" assigned to automatic zone "Zone 1"
b. cause2: "All test modes" assigned to automatic zone "Zone 2"
c. cause3: "All isolations" assigned to automatic zone "Zone 1"
d. cause4: "All isolations" assigned to automatic zone "Zone 2"
e. cause5: "All activation" assigned to XC10 zone "Extinguishing"
2:Output 'Block autom.'
f. effect: assign to FDCIO OUT 2 (Relay B)
A6V10257473_e_en_--
2015-03-04