Call Home; Zoning Configuration Parameters; Fault Monitoring And Reporting; Set Port Command Changes - Qlogic SANbox 9000 Series Interface Manual

A
1.3.1

Call Home

This feature improves fabric availability by notifying adminstrators by email of
events that afffect switch operation. The following commands have been modified:
Set Setup Services
Show Setup Services
Set Log
Show Log
The following commands have been added:
Callhome
Profile
Set Setup Callhome
Show Setup Callhome
1.3.2

Zoning Configuration Parameters

The following zoning configuration parameters have changed:
InteropAutoSave is now named MergeAutoSave; function is the same.
DefaultZone values have changed from True/False to Allow/Deny; function
is the same.
1.3.3

Fault Monitoring and Reporting

The feature monitors the switch for system and blade faults. A fault is an event
that may require assistance from your authorized maintenance provider. The
following command displays have been modified:
Show About, Show Version
Show Blade
Show Chassis
Show Switch
The Show Faults command has been added:
1.3.4

Set Port Command Changes

The Set Port command keywords Bypass and Enable have been removed.
59231-03 A
1 – Introduction
New in This Release
1-3