Configuring The Timeout Interval For A Server - Cisco nexus 5000 series Cli Configuration Manual

Configuring TACACS+
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Configuring the Global TACACS+ Timeout Interval
You can set a global timeout interval that the Nexus 5000 Series switch waits for responses from all
TACACS+ servers before declaring a timeout failure. The timeout interval determines how long the
Nexus 5000 Series switch waits for responses from TACACS+ servers before declaring a timeout failure.
Command
Step 1
switch# configure terminal
Step 2
switch(config)# tacacs-server timeout
seconds
Step 3
switch(config)# exit
Step 4
switch# show tacacs-server
Step 5
switch# copy running-config startup-config

Configuring the Timeout Interval for a Server

You can set a timeout interval that the Nexus 5000 Series switch waits for responses from a TACACS+
server before declaring a timeout failure. The timeout interval determines how long the Nexus 5000
Series switch waits for responses from a TACACS+ server before declaring a timeout failure.
To configure the timeout interval for a server, perform this task:
Command
Step 1
switch# configure terminal
Step 2
switch(config)# switch(config)#
tacacs-server host
{ipv4-address|ipv6-address|host-name}
timeout seconds
Step 3
switch(config)# exit
Step 4
switch# show tacacs-server
Step 5
switch# copy running-config startup-config
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
1-10
Chapter 1
Purpose
Enters configuration mode.
Specifies the timeout interval for TACACS+ servers.
The default timeout interval is 5 second and the
range is from 1 to 60 seconds.
Exits configuration mode.
(Optional) Displays the TACACS+ server
configuration.
(Optional) Copies the running configuration to the
startup configuration.
Purpose
Enters configuration mode.
Specifies the timeout interval for a specific server.
The default is the global value.
The timeout interval value specified for a
Note
TACACS+ server overrides the global
timeout interval value specified for all
TACACS+ servers.
Exits configuration mode.
(Optional) Displays the TACACS+ server
configuration.
(Optional) Copies the running configuration to the
startup configuration.
Configuring TACACS+
OL-16597-01