Displaying Scsi Lun Information - Cisco nexus 5000 series Cli Configuration Manual

Chapter 1 Discovering SCSI Targets

Displaying SCSI LUN Information

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Displaying SCSI LUN Information
Use the show scsi-target and show fcns database commands to display the results of the discovery.
The following example displays the discovered targets:
switch# show scsi-target status
discovery completed
This command takes several minutes to complete, especially if the fabric is large or if several devices
Note
are slow to respond.
The following example displays the FCNS database:
switch# show fcns database
The following example displays the SCSI target disks:
switch# show scsi-target disk
The following example displays the discovered LUNs on all operating systems:
switch# show scsi-target lun os all
The following example displays the port WWN that is assigned to each operating system (Windows,
AIX, Solaris, Linux, or HPUX):
switch# show scsi-target pwwn
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
1-3
OL-16597-01