Cisco nexus 5000 series Cli Configuration Manual page 59

Chapter 1 Configuring the Switch
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Enter yes (yes is the default) to configure the IPv4 default gateway (recommended).
Step 9
Configure the default-gateway: (yes/no) [y]: yes
Enter the default gateway IPv4 address.
a.
IPv4 address of the default-gateway: default_gateway
Enter yes (yes is the default) to enable the Telnet service.
Step 10
Enable the telnet service? (yes/no) [y]: yes
Enter yes (no is the default) to enable the SSH service.
Step 11
Enabled SSH service? (yes/no) [n]: yes
Enter the SSH key type that you would like to generate.
Step 12
Type the SSH key you would like to generate (dsa/rsa/rsa1)? dsa
Enter the number of key bits within the specified range.
Step 13
Enter the number of key bits? (768 to 2048): 768
Enter yes (no is the default) to configure the NTP server.
Step 14
Configure NTP server? (yes/no) [n]: yes
Enter the NTP server IPv4 address.
a.
NTP server IP address: ntp_server_IP_address
Step 15 Enter yes (yes is the default) to configure basic Fibre Channel configurations.
Enter basic FC configurations (yes/no) [n]: yes
Step 16 Enter shut (shut is the default) to configure the default Fibre Channel switch port interface to the shut
(disabled) state.
Configure default physical FC switchport interface state (shut/noshut) [shut]: shut
Step 17 Enter on (on is the default) to configure the switch port trunk mode.
Configure default physical FC switchport trunk mode (on/off/auto) [on]: on
Enter permit (deny is the default) to deny a default zone policy configuration.
Step 18
Configure default zone policy (permit/deny) [deny]: permit
Permits traffic flow to all members of the default zone.
If you are executing the setup script after entering a write erase command, you explicitly must change
Note
the default zone policy to permit for VSAN 1 after finishing the script using the following command:
switch(config)# zone default-zone permit vsan 1
Enter yes (no is the default) to enable a full zone set distribution.
Step 19
Enable full zoneset distribution (yes/no) [n]: yes
Overrides the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
Step 20 Enter no (no is the default) if you are satisfied with the configuration.
OL-16597-01
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Initial Configuration
1-11