Enabling Autoreconfiguration; Domain Ids; About Domain Ids - Cisco nexus 5000 series Cli Configuration Manual

Chapter 1 Configuring Domain Parameters
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

Enabling Autoreconfiguration

To enable automatic reconfiguration in a specific VSAN (or range of VSANs), perform this task:
Command
Step 1
switch# configuration terminal
switch(config)#
Step 2
switch(config)# fcdomain auto-reconfigure vsan
vsan-id
switch(config)# no fcdomain auto-reconfigure vsan
vsan-id

Domain IDs

Domain IDs uniquely identify a switch in a VSAN. A switch may have different domain IDs in different
VSANs. The domain ID is part of the overall FC ID.
This section describes how to configure domain IDs and includes the following topics:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

About Domain IDs

The configured domain ID can be preferred or static. By default, the configured domain ID is 0 (zero)
and the configured type is preferred.
The 0 (zero) value can be configured only if you use the preferred option.
Note
OL-16597-01
About Domain IDs, page 1-7
Specifying Static or Preferred Domain IDs, page 1-9
About Allowed Domain ID Lists, page 1-10
Configuring Allowed Domain ID Lists, page 1-10
About CFS Distribution of Allowed Domain ID Lists, page 1-11
Enabling Distribution, page 1-11
Locking the Fabric, page 1-11
Committing Changes, page 1-12
Discarding Changes, page 1-12
Clearing a Fabric Lock, page 1-12
Displaying CFS Distribution Status, page 1-12
Displaying Pending Changes, page 1-13
Displaying Session Status, page 1-13
About Contiguous Domain ID Assignments, page 1-13
Enabling Contiguous Domain ID Assignments, page 1-14
Purpose
Enters configuration mode.
Enables the automatic reconfiguration
option in the specified VSAN.
Disables the automatic reconfiguration
option and reverts it to the factory default in
the specified VSAN.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Domain IDs
1-7