Cisco nexus 5000 series Cli Configuration Manual page 58

Initial Configuration
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Tip
Enter yes to enter the setup mode.
Step 3
This setup utility will guide you through the basic configuration of
the system. Setup configures only enough connectivity for management
of the system.
*Note: setup is mainly used for configuring the system initially,
when no configuration is present. So setup always assumes system
defaults and not the current system configuration values.
Press Enter at anytime to skip a dialog. Use ctrl-c at anytime
to skip the remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no): yes
The setup utility guides you through the basic configuration process. Press Ctrl-C at any prompt to end
the configuration process.
Enter the new password for the administrator (admin is the default).
Step 4
Enter the password for admin: admin
Enter yes (no is the default) to create additional accounts.
Step 5
Create another login account (yes/no) [n]: yes
While configuring your initial setup, you can create an additional user account (in the network-admin
role) besides the administrator's account. See the
information on default roles and permissions.
Enter the user login ID.
a.
Enter the user login ID: user_name
Enter the user password.
b.
Enter the password for user_name: user-password
Enter yes (yes is the default) to create an SNMP read-only community string.
Step 6
Configure read-only SNMP community string (yes/no) [n]: yes
SNMP community string: snmp_community
Enter a name for the switch.
Step 7
Note
Enter the switch name: switch_name
Enter yes (yes is the default) to configure out-of-band management.
Step 8
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
a. Enter the mgmt0 IPv4 address.
Mgmt0 IPv4 address: ip_address
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
1-10
If a password is weak (short, easy-to-decipher), your password configuration is rejected. Be sure
to configure a strong password. Passwords are case-sensitive.
The switch name is limited to 32 alphanumeric characters. The default is switch.
Chapter 1
"Configuring RBAC" section on page 1-5
Configuring the Switch
for
OL-16597-01