Cisco nexus 5000 series Cli Configuration Manual page 195

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Configuring Access and Trunk Interfaces
Ethernet interfaces can be configured either as access ports or trunk ports. Trunks carry the traffic of
multiple VLANs over a single link and allow you to extend VLANs across the network.
This chapter includes the following sections:
•
•
•
Information About Access and Trunk Interfaces
This section includes the following topics:
•
•
•
•
•
Cisco NX-OS supports only IEEE 802.1Q-type VLAN trunk encapsulation.
Note
Understanding Access and Trunk Interfaces
Ethernet interfaces can be configured either as access ports or a trunk ports, as follows:
•
•
Figure 1-1
more VLANs.
OL-16597-01
Information About Access and Trunk Interfaces, page 1-1
Configuring Access and Trunk Interfaces, page 1-4
Verifying Interface Configuration, page 1-8
Understanding Access and Trunk Interfaces, page 1-1
Understanding IEEE 802.1Q Encapsulation, page 1-2
Understanding Access VLANs, page 1-3
Understanding the Native VLAN ID for Trunk Ports, page 1-3
Understanding Allowed VLANs, page 1-4
An access port can have only one VLAN configured on the interface; it can carry traffic for only one
VLAN.
A trunk port can have two or more VLANs configured on the interface; it can carry traffic for several
VLANs simultaneously.
show how you can use trunk ports in the network. The trunk port carries traffic for two or
C H A P T E R
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
1
1-1