Koncar SE 5640 SERIES Operating, Installation And Connecting Instructions page 70

Connecting procedure
- To connect the cooker, it is NOT NECESSARY to remove the rear panel of the cooker.
- With a screw driver, release the connection box cover to get access to the connection
terminals (Figure 35).
MAKE SURE that the connection cable is inserted through
an appropriate support, which is an integral part of the
connection box and keeps the cable in place (Figure 36).
Stove must additionally attached to the wall as shown in
Figure 32.
The length of the connection cable protective earth
conductor should be such that, if the connection cable were
to slip in its anchorage, the protective earth conductor
would be the last to take the strain.
-Connect the cable to the terminals as shown in the Figures 33, 34-1, 34-2 or 34-3, taking into
account that, subject to the connection method, bridges should be installed.
- Tighten or press firmly the cable support and close the junction box cover (Figure 37).
Note :
Connection bridges are already provided in the junction box. Screws of the connection
terminals are already in open position and need not be loosened. While tightening the
screw, a "click" sound is heard indicating that the screw should be fully tightened.
EN
Figure 35
70
Figure 36
Figure 37