Siemens SCALANCE X-200 Configuration Manual page 81

Note
When supplied, SSH and TELNET are activated.
When supplied, DHCP (identification via MAC address) is enabled.
When the device ships, Mgmnt ACL is disabled.
Settings for X-200 IE switches
Agent Enabled Features
E-Mail
Enables/disables E-mail functionality.
TELNET
Enables/disables the availability of the IE Switch X-200 over TELNET.
SSH
Enables / disables the SSH protocol.
DHCP
Enables/disables the search by the IE switch X-200 for a DHCP server when it starts up. The
IP parameters of the X-200 are configured according to the data supplied by this server.
If DHCP is enabled, the "Agent DHCP Type" section is available. Select one of the options
for identifying the IE switch X-200 in the configuration of the DHCP server.
DCP Read Only
The configuration of an X-200 can be read and edited via DCP (PST tool and STEP 7).
If you enable the "DCP Read Only" option, the configuration data can only be read via DCP.
Mgmnt ACL
Note
Note the following before you enable "Mgmnt ACL"
A bad configuration on the "Management ACL" page can result in you being unable to
access your device. You should therefore configure an access rule that allows access to the
management before you enable the function.
Enable/disable the rules for accessing the management of the IE switch.
The access rules are managed on the "Management ACL" page, see section "Management
ACL (Page 111)".
Agent IP Configuration
IP Address
The IP address of the X-200 IE switch. If you make a change here, the WBM loses the
connection to the X-200 IE switch. Enter the new address in the Internet browser to
reestablish the connection.
Subnet Mask
Here, you enter the subnet mask of the X-200 IE switch.
SCALANCE X-200
Configuration Manual, 03/2015, C79000-G8976-C285-06
Menus in the WBM
5.3 The Agent menu
81