Table of Contents
Advertisement
Using the Command and Response Table
The
throughout the table to represent variables in the command and response fields. Command
and response examples are shown throughout the table. The ASCII to HEX conversion table
below is for use with the command and response table.
Space
Symbol definitions
]
= Carriage return/line feed
}
= Carriage return (no line feed)
|
= Pipe (can be used interchangeably with the
•
= space
E
= Escape key
W
= Can be used interchangeably with the
X!
= Input number
X@
= Switch mode
X#
= Status
X$
= HDMI input
X%
= Input HDCP status
X^
= Output HDCP status
X&
= EDID
X*
= User EDID location
X(
= Raw EDID data
X1)
= Resolution and rate in plain text
X1!
= Analog input video format
X1@
= Switcher name
X1#
= Firmware version number to second decimal place (x.xx)
X1$
= Verbose mode
command and response table
ASCII to Hex Conversion Table
}
character)
E
character
or
through
0
1
assignment)
= Manual (default)
0
= Auto-input switching high
1
= Off, disabled, or not detected
0
or
2
3
= No source is detected
0
= Source is detected with HDCP
1
= Source detected without HDCP
2
= No sink is detected
0
= Sink is detected with HDCP
1
= Sink is detected without HDCP
2
See
table 1
on page 16.
,
, or
66
67
68
128 or 256 bytes of hexadecimal data
Example:
1920x1200
= Auto detect (default)
0
A text string of up to 24 alphanumeric characters and minus sign/hyphen (-).
No blank or space characters are permitted as part of a name. The first letter must a
letter, and the last character must not be a minus sign/hyphen.
0 = clear/none (default)
1 = verbose mode (default for RS-232 or USB)
begins on the next page. Symbols are used
•
(
= no input for switching command or always output for audio
3
0
= Auto-input switching low
2
= on, enable, or detected
1
•
@60Hz
= RGB (VGA)
1
DTP T USW 233 • Remote Control
= YUV/component video
2
2 = tagged responses for queries
3 = verbose mode and tagged for queries
14
Advertisement
Table of Contents
