Minolta CF5001 User Manual page 131

Checking Feature Selections / Proof Copying (Check Mode) (continued)
6.
Press [PROOF COPY] on the control panel or touch PROOF COPY on
the Check Screen.
A sample copy will be output.
• Press [STOP] to suspend the proof copying. In this case, the scanned image
• You cannot change or release selections that appeared dimmed after proof
• When the copy result is satisfactory, proceed to the next step.
• When any setting change is required, return to step 4, then repeat proof copying, as
required.
If the desired selection cannot be changed, press [STOP] to delete all the data in
memory, then press [AUTO RESET] to restart the job setting.
7.
Change the copy quantity or other conditions, as required.
Proof copy can be performed as needed, until the print quantity amount on the
Basic Screen reaches zero. (Note that the print quantity amount on the Check
Screen does not change.)
If required, change the print quantity on the Basic Screen.
8.
Press [START].
If the print quantity is not changed, the copier will output the rest, except the sample sets.
When the finisher / trimmer unit / paper exit tray capacity is exceeded
due to the print quantity selected, remove the copied sets as they
exit; otherwise, mishandled paper will occur.
data will not be deleted from memory.
copying.
4
Helpful
Functions
Proof Copy
Check Mode
Interrupt
Mode
Job Memory
Recalling
Previous Settings
Help Mode
4-7