Rep 16 Scanner Retard Pad - Xerox FaxCentre 2121 Service Manual

Repairs and Adjustments

REP 16 Scanner Retard Pad

Parts list on PL 4
Switch off the electricity to the machine. Disconnect the power cord from the customer supply
while performing tasks that do not need electricity. Electricity can cause death or injury. Moving
parts can cause injury.
Removal
1. Stand at the back of the machine.
2. Press the top cover release latch.
3. Press outwards on the latch and release the stop.
4. Hold the retard pad assembly while removing the mounting screw. Remove the assembly.
Note: The fixing plate is attached to a ground wire. Move the plate to one side to remove the
remaining parts.
Side blade spring
Slide plate
Replacement
1. Visually inspect the new parts.
2. Put the new parts in place on the control panel in the following order: Slide plate, retard pad,
centre blade spring, side blade spring and fixing plate. Make sure the parts are oriented cor-
rectly. Insert the mounting screw and tighten it.
3. Press on the latch and close the control panel, letting the stop lock behind the latch.
4-32
WARNING
Figure 1
11/06
Mounting screw
Fixing plate
Centre blade
spring
Retard pad
FaxCentre 2121/2121L