General Procedures and Information
Fuser Assembly Temperature Control
Temperature change
Table 1: Thermistor-Detected Temperature at Start of Temperature Control
Mode before
Power OFF
Tempera-
Mode 1
ture Control
Mode 2
Mode 3
Temperature control
•
During a warm-up cycle, the fuser temperature is increased to a predetermined level.
•
The warm-up control is performed when the power is turned ON, the front door is opened and
closed, and the pause mode is cancelled.
•
During the standby state, the fuser temperature is kept lower (130°C) than during printing so
as to economize on power consumption.
6-64
Figure 2
Less than 50°C
(122°F)
Mode 1
11/06
50°C to 130°C
(122°F to 266°F)
Mode 2
Mode 1
Mode 2
More than 130°C (266°F)
Mode 3
Mode 3
FaxCentre 2121/2121L