General Procedures and Information
Electrical Requirements
Power
Single-phase AC supply with ground, in conformance with the information on the label on the back
of the machine.
Note: The power input of the machine conforms to the over voltage safety level.
Note: The machine cannot be connected to an IT type power supply.
Telephone line
The telephone line is equipped with a standardized telephone connector and should be connected
to the switched telephone network (private exchange (PABX) or public exchange).
Note: The telephone line input conforms to the TNV-3 safety level
Environmental Conditions
When selecting a location for the machine, the following points should be taken into account:
•
The telephone socket should be located no more than 2 meters(6.5 feet) from a telephone
socket.
•
A standard single-phase power socket with ground (rated in conformance with the information
on the label on the back of the fax) should be located at no more than 2 meters(6.5 feet)
•
For easy access to the machine, leave a space of about 10 cm(3.9 inches) at the sides and
the back. Also leave sufficient space in front of the machine.
•
Do not install the machine in direct sunlight, near heating radiators or near air conditioning
outlets.
•
The room should be adequately ventilated.
•
Avoid locations where frequent vibrations occur.
•
Avoid locations where water or other products might be splashed on the machine.
•
The machine should not be installed directly on the floor.
•
Place the machine on a flat horizontal support.
6-14
11/06
FaxCentre 2121/2121L