Environmental Conditions - Xerox FaxCentre F116 Service Manual

General Procedures/Information
Electrical requirements
Power
Single-phase AC supply with ground, in conformance with the information on the label on the back
of your machine.
Note(s) : The input power of the machine conforms to the overvoltage safety level.
Telephone line
The telephone line is equipped with a standardized telephone connector and should be connected
to the switched telephone network (private exchange (PABX) or public exchange).
Note(s) : The telephone line input conforms to the TNV-3 safety level.

Environmental conditions

When selecting a location for the machine, the following points should be taken into account:
• The telephone socket should be located at no more than 2 meters (6 feet).
• A standard single-phase power socket with ground (rated in conformance with the infor-
mation on the label on the back of the machine) should be located at no more than 2
meters (6 feet).
• For easy access to the machine, leave a space of about 10 cm (4 inches). at the sides
and the back. Also leave sufficient space in front of the machine.
• If the machine is installed close to a wall, make sure the distance between the wall and
the upper edge of the tray is at least 10 inches (25 centimeters). This will allow for eas-
ier opening of the upper cover.
• Do not install the machine in direct sunlight, near heating radiators or near air condition-
ing outlets (see
• The room should be adequately ventilated.
• Avoid locations where frequent vibrations occur.
• Avoid locations where water or other products might be splashed on the machine.
• The machine should not be installed directly on the floor.
• Place the machine on a flat horizontal support.
6-12
GP 1).
9/04 FaxCentre F116/F116L