Logging On To The Web Interface - Lenovo Flex System x280 X6 Compute Node Installation And Service Manual

The rear of the network access tag lists the IPv6 link local address (LLA), as shown
in the following illustration.
The MAC address is also available through the Setup utility, the CMM cinstatus
command, and the CMM web interface.
v For more information about the Setup utility, see "Using the Setup utility" on
v For more information about the CMM cinstatus command, see the "Flex System
v From the CMM web interface, select Compute Nodes from the Chassis
Note: If the network access tag is missing from the front of the compute node, you
can also locate the MAC address on a label located on the bottom of the compute
node.

Logging on to the web interface

Use these instruction to log in to the IMM2 web interface.
Notes:
v If you are logging on to the IMM2 for the first time after installation, the IMM2
v You can also assign IP addresses through the CMM ifconfig command. For more
50
Flex System x280 X6, x480 X6, and x880 X6 Compute Node Types 7903 and 4259: Installation and Service Guide
page 29.
Chassis Management Module: Command-Line Interface Reference Guide" at
http://pic.dhe.ibm.com/infocenter/flexsys/information/topic/
com.ibm.acc.cmm.doc/cli_command_cinstatus.html.
Management menu. For more information, see the "Flex System Chassis
Management Module: User's Guide" at http://pic.dhe.ibm.com/infocenter/
flexsys/information/topic/com.ibm.acc.cmm.doc/cmm_user_guide.html. All
fields and options are described in the CMM web interface online help.
defaults to Dynamic Host Configuration Protocol (DHCP). If a DHCP host is not
available, the IMM2 assigns a static IP address between 192.168.70.101 and
192.168.70.114, depending on the bay in which the compute node is installed.
information about the CMM ifconfig command, see the "Flex System Chassis
Management Module: Command-Line Interface Reference Guide" at
http://pic.dhe.ibm.com/infocenter/flexsys/information/topic/
com.ibm.acc.cmm.doc/cli_command_ifconfig.html.