Installing The Light Path Diagnostics Panel - Lenovo Flex System x280 X6 Compute Node Installation And Service Manual

2. If the compute node is installed in an Flex System chassis, remove it (see
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
Procedure
To remove the light path diagnostics panel, complete the following steps.
1. Remove the cover (see "Removing the compute node cover" on page 715).
2. Pull the light path diagnostics panel out of the bracket.
3. Disconnect the cable from the system board.
4. Lift the light path diagnostics panel from the compute node.
What to do next
If you are instructed to return the light path diagnostics panel, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.

Installing the light path diagnostics panel

Use this information to install the light path diagnostics panel.
Before you begin
Before you install the light path diagnostics panel, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 699.
2. If the compute node is installed in an Flex System chassis, remove it (see
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
744
Flex System x280 X6, x480 X6, and x880 X6 Compute Node Types 7903 and 4259: Installation and Service Guide
"Removing a compute node from a chassis" on page 701 for instructions).
compute node with the bezel pointing toward you.
"Removing a compute node from a chassis" on page 701 for instructions).
compute node with the bezel pointing toward you.