Lenovo Flex System x280 X6 Compute Node Installation And Service Manual page 303

CIM Information: Prefix: PLAT and ID: 0184
SNMP Trap ID: 50
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI diagnostic code for this event can be found in the logged
IMM message text. Please refer to the UEFI diagnostic code in the "UEFI diagnostic code" section of the Information
Center for the appropriate user response.
Related Links:
"Finding the UEFI diagnostic code" on page 648
v
806f0013-1701ffff A diagnostic interrupt has occurred on system [ComputerSystemElementName].
Explanation: The user has pressed the NMI button, or the NMI button has malfunctioned.
May also be shown as 806f00131701ffff or 0x806f00131701ffff
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0222
SNMP Trap ID: 50
Automatically notify Support: No
User response: If the NMI button on the operator information panel has not been pressed, complete the following
steps:
1. Make sure that the NMI button is not pressed.
2. Replace the system board.
806f001e-2201ffff No bootable media available for system [ComputerSystemElementName].
Explanation: No boot device has been detected in the system.
May also be shown as 806f001e2201ffff or 0x806f001e2201ffff
Severity: Info
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0286
SNMP Trap ID:
Automatically notify Support: No
User response: Please install and configure a boot media, and attempt to power on and boot the server, again.
806f0021-1201ffff Fault in slot [PhysicalConnectorSystemElementName] on system
[ComputerSystemElementName].
Explanation: A SMP scaling connector fault has been detected in the system.
May also be shown as 806f00211201ffff or 0x806f00211201ffff
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0330
SNMP Trap ID: 50
806f0013-1701ffff • 806f0021-1201ffff
Chapter 6. Troubleshooting
291