Removing And Replacing Frus (Trained Service Technician Only); Removing A Microprocessor And Heat Sink - Lenovo Flex System x280 X6 Compute Node Installation And Service Manual

Types 7903 and 4259

Hide thumbs Also See for Flex System x280 X6 Compute Node:

Table of Contents

To install the USB flash drive, complete the following steps.

1. Remove the cover (see "Removing the compute node cover" on page 715).

2. Locate the USB connectors on the system board.

3. Push the USB flash drive into the connector.

What to do next

After you install the USB flash drive, complete the following steps:

1. Install the cover onto the compute node (see "Installing the compute node

2. Install the compute node into the chassis (see "Installing a compute node in a

Removing and replacing FRUs (trained service technician only)

Use this information to remove and replace field replaceable units (FRUs).

About this task

The FRUs that are described in this section must be installed only by trained

service technicians.

Use this information to remove a microprocessor and heat sink.

Before you begin

Note: This procedure should be performed only by trained service technicians.

Before you remove the microprocessor and heat sink, complete the following steps:

Flex System x280 X6, x480 X6, and x880 X6 Compute Node Types 7903 and 4259: Installation and Service Guide

Note: You might have to remove an I/O expansion adapter to remove the

USB flash drive.

cover" on page 716 for instructions).

chassis" on page 702 for instructions).