Jib Boom Components; Jib Boom - Genie S-40 Service Manual

Section 4 • Repair Procedures
Jib Boom Components, S-45
3-1

Jib Boom

How to Remove the Jib Boom
Note: Perform this procedure with the boom in the
stowed position.
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose end must be
replaced and then torqued to specification during
installation.
Refer to Section 2, Hydraulic Hose and Fitting
Torque Specifications.
1 Remove the platform.
2 Remove the platform mounting weldment,
and the platform rotator. See 2-2, How to
Remove the Platform Rotator .
3 From the ground controls, raise the jib boom to
a horizontal position.
4 Support the jib boom with a strap from an
overhead crane.
5 Tag, disconnect and plug the hydraulic hoses
from the jib boom lift cylinder. Cap the fittings
on the cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
4 - 14
6 Remove the hose cover, hoses and cables from
7 Place blocks under the platform leveling cylinder
8 Remove the pin retaining fasteners from the jib
9 Attach a lifting strap from an overhead crane to
10 Use a soft metal drift to remove the jib boom lift
11 Use a soft metal drift to remove the jib boom lift
12 Remove the pin retaining fasteners from the jib
S-40 • S-45 • S-40 TRAX • S-45 TRAX
the side of the jib boom and set them aside.
Component damage hazard. Hoses
and cables can be damaged if they
are kinked or pinched.
for support. Protect the cylinder rod from
damage.
boom lift cylinder barrel-end pivot pin. Do not
remove the pin.
the lug on the rod end of the jib boom lift
cylinder.
cylinder rod-end pivot pin.
cylinder barrel-end pivot pin, then remove the
jib boom cylinder.
Crushing hazard. The jib boom
lift cylinder could become
unbalanced and fall when it is
removed from the machine if it is
not properly attached to the
overhead crane.
boom pivot pin. Use a soft metal drift to remove
the pin, then remove the jib boom from the
bellcrank.
Crushing hazard. The jib boom
could become unbalanced and fall
when it is removed from the
machine if it is not properly
attached to the overhead crane.
February 2014
Part No. 826364