Genie S-40 Service Manual page 109

February 2014
10 Turn the key switch to ground control.
11 Test all machine functions from the ground
controls.
Result: All ground control functions utilizing
engine power should not operate. (Only limited
ground control functions utilizing APU power
should function).
12 Using a suitable lifting device, lift the test weight
off the platform floor.
Result: The platform overload indicator light
should be off at both the ground and platform
controls and the alarm should not sound.
Note: There may be a 2 second delay before the
overload indicator lights and alarm turn off.
13 Start the engine from the ground controls.
14 Test all machine functions from the ground
controls.
Result: All ground control functions should
operate normally.
15 Turn the key switch to platform control.
16 Test all machine functions from the platform
controls.
Result: All platform control functions should
operate normally.
Part No. 826364 S-40 • S-45 • S-40 TRAX • S-45 TRAX
Section 4 • Repair Procedures
PLATFORM COMPONENTS
4 - 13