Genie S-40 Service Manual page 52

Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
3 Open the engine pivot plate latch and swing the
engine pivot plate out and away from the
machine.
4 Inspect the following areas for burnt, chafed,
corroded and loose wires:
• Engine wiring harness
• Hydraulic manifold wiring
5 Open the ground controls side turntable cover.
6 Inspect the following areas for burnt, chafed,
corroded and loose wires:
• Ground control box wire harnesses
• Inside of the ground control box
• Hydraulic manifold wiring
7 Inspect for a liberal coating of dielectric grease
at the following location:
• All wire harnesses connectors to the
ground control box
8 Start the engine from the ground controls and
raise the secondary boom above the turntable
covers.
9 Remove the center turntable cover retaining
fasteners. Remove the center turntable cover
from the machine.
3 - 18
10 Inspect the turntable area for burnt, chafed and
11 Lower the boom to the stowed position and turn
12 Inspect the following areas for burnt, chafed,
13 Inspect for a liberal coating of dielectric grease
14 Swing the engine back to its original position
15 Install the engine pivot plate safety pin.
16 Install the center turntable cover and tighten the
S-40 • S-45 • S-40 TRAX • S-45 TRAX
pinched cables.
the engine off.
corroded, pinched and loose wires:
• Cable track on the primary boom
• Cables on the primary, and jib booms
• Jib boom/Platform rotate manifold
• Inside of the platform control box
at the following location:
• All wire harnesses connectors to the
platform control box
and close the engine pivot plate latch.
retaining fasteners.
October 2014
Part No. 826364