Perform Engine Maintenance Ford Models - Genie S-40 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST C PROCEDURES
3 Move the function enable toggle switch to the
high idle (rabbit symbol) position. Refer to
Section 2 , Specifications .
If high idle rpm is correct, disregard adjustment
step 4.
4 Loosen the yoke lock nut. Turn the high idle
adjustment nut and solenoid boot
counterclockwise to increase the rpm or
clockwise to decrease the rpm. Tighten the
yoke lock nut and re-check the rpm.
Note: Be sure the solenoid fully retracts when
activating high idle.
3 - 44
C-8
Perform Engine Maintenance -
Ford Models
Engine specifications require that this procedure be
performed every 800 hours.
Required maintenance procedures and additional
engine information are available in the
Ford MSG-425 EFI Operator Handbook
(Ford part number 1020010)
Ford MSG-425 EFI Operator Handbook
Genie part number
S-40 • S-45 • S-40 TRAX • S-45 TRAX
• PCV valve - inspect
• PCV hoses, tubes and fittings - clean
October 2014
215322
Part No. 826364