Using The Multiple Start Bartack As The Darning Program - Dürkopp Adler 1767 Operating Instructions Manual

58
5.2.3 Using the multiple start bartack as the darning
program
Information
The darning program is only supported by certain classes.
Order
If you want to use the multiple start bartack as the darning program,
it has to be released in advance by qualified specialists
( Service Instructions).
The darning program offers the following functions:
• The thread is cut at the end of the program.
To set the darning program:
1. Check whether the thread cutter
( p. 60).
2. Press.
 The LED illuminates.
Press the A+ button from the Programming button group
3.
repeatedly until the required number of forward stitches is
reached.
Press the B+ button repeatedly until the required number of
4.
backward stitches is reached.
Press the C+ button to set the start of path 1.
5.
Press the D+ button repeatedly until the required number of
6.
repetitions is reached.
Important
If the number of repetitions = 0, the program will continue working
until stopped by the pedal.
7. Confirm your selection with .
Operating Instructions 1767 - 00.0 - 12/2016
Programming
has been activated