Dürkopp Adler 1767 Operating Instructions Manual page 27

Operation
Operating Instructions 1767 - 00.0 - 12/2016
10. Guide the needle thread from the bottom through the thread
guide (11) and through the needle thread regulator (12).
11. Insert the needle thread from the right to the left through the
thread lever (4).
12. Insert the needle thread through thread guide (11).
13. Insert the needle thread through thread guide (10).
14. Insert the thread through the needle eye.
Important
Check the thread length.
The thread cutter does not function correctly when the loose thread
end is too long.
For machines with a short thread cutter
Fig. 8: Needle thread threading on 1-needle machines (3)
15. Insert the thread through the right hole of the guide above the
thread clamp.
16. Insert the thread through the right hole of the guide below the
thread clamp.
17. Insert the thread into the thread clamp from the right so that
the thread is held in place inside the hook of the clamp.
 The thread is supposed to run through the clamp almost
without touching it and in such a way that it only makes con-
tact with the guides above and below the thread clamp.
18. Insert the thread through the thread guide on the needle
bar (13).
25