Table of Contents
Advertisement
80
7.3
Assembling the stand
Fig. 34: Assembling the stand
①
②
③
④
⑤
(1) - Head sections of the inner bars
(2) - Inner bars
(3) - Stand bars
(4) - Cross bar
To assemble the stand:
1.
Screw the cross bar (4) to the stand bars (3).
2.
Screw the oil can holder (8) at the rear to the cross bar (4).
3.
Screw the cross strut (6) to the foot struts (5).
4.
Insert the inner bars (2) in such a way that the longer end
of the head section (1) is above the longer end of the foot
struts (5).
5.
Tighten the inner bars (2) down so that both head sections (1)
are at the same height.
Important
Turn the adjusting screw (7) so that the stand has even contact
with the ground.
⑥
(5) - Foot struts of the stand
(6) - Cross strut
(7) - Adjusting screw (not shown)
(8) - Holder for oil can
Operating Instructions 1767 - 00.0 - 12/2016
Setup
⑧
②
③
⑤
Hide quick links:
Advertisement
Table of Contents
