Aastra Dialog 4425 IP Vision User Manual page 138

Group Services
Select
ÅÆÇ
SEC. IN/OUT
í
138
Press the dynamic function key shown on the left in order to
highlight the number "1", which corresponds to the activation/
deactivation of your extension within your primary group.
Press the dynamic function key shown on the left.
If your extension was initially "ACTIVE" within your primary group –
as shown on the right of the "1 Hunt group" option, your extension
will now change to the standby status.
On the other hand, if your extension is on standby – shown by the
"UNACTIVE" status – it will then return to the "ACTIVE" status
within your primary group.
Press and hold the centre navigation key on your extension
for 2 seconds.
Your extension returns to the idle status.
When your extension is on standby within your primary group, its
status is represented on your idle extension with an "S" displayed
on the first line of the screen.
Settings
CS
Your standby status within secondary groups is managed through
dialling, for all of your secondary groups as a whole.
z
From your idle extension:
Dial the prefix for setting your extension to standby within
secondary groups.
This varies from one facility to another. You may consult the guide
integrated within your extension in order to find the prefix that has
been defined for this purpose for your facility. See the
"Programming Your Extension's
Call
Press the dynamic function key shown on the left.
A confirmation that the service was accepted is provided both visually
and audibly; the "Accepted Service" message is displayed on the
screen, and the accepted service tone is played.
Press the "C" key to end this service.
If your extension was active, it will now be on standby within all of
your secondary groups
On the other hand, if your extension was on standby, it will now be
active within all of your secondary groups.
CallList
Log off
MD Evolution – Dialog 4425 IP Vision
PhoneBook WAP Services
15:49
SMITH Peter
405
2 Missed
Services" section.
07 Nov 2008