Slave Mode - SHOWTEC POWER SPOT 9 G6 TOUR V1 Manual

Power Spot 9 Q6 Tour
7. Built-in programs
With this menu you can you can set the built-in programs.
01) Press the MODE button until the display shows
02) Press the SETUP button to open this menu.
03) You can use the UP/DOWN buttons to scroll through the 12 built-in programs.
04) You can use the SETUP button to open menu
05) Use the UP/DOWN buttons to choose a color setting.
06) You can use the SETUP button to change the flash frequency of every color from
This does not apply for the color setting
07) When you select
built-in programs.
08) You can choose 2 different sub menus.
09) Use the SETUP button to open one of these menus or to switch between both menus.
10) Use the UP/DOWN buttons to change the speed from
11) Use the UP/DOWN buttons to change the flash frequency from

8. Slave Mode

With this menu you can set the slave mode.
01) Press the MODE button and then the UP/DOWN buttons, until the display shows
If the device has not been set to slave, it is automatically classified as a master device. All slave
devices will follow the master movement. If the device has been set to slave, it will react the same as
its master device.
Ordercode: 42576
.
, you can press the UP/DOWN buttons to switch between the
Speed from 000-100.
Flash Frequency from 000-099.
.
.
17
.
.
.
.