Dmx Mode; Master/Slave Mode; Channel Mode; Sound Control Mode - SHOWTEC Ignitor-6 Section Strobe Manual

1. DMX Mode

With this menu you can set the DMX address.
1) Press the Up / Down buttons, until the display shows
2) Press Enter to enter the DMX Mode. You can choose 512 different DMX addresses.
Use the Up / Down buttons to select the required address from

2. Master/Slave Mode

1) Press the Up / Down buttons, until the display shows
2) Press Enter to enter the Slave Mode. You can choose 2 different modes.
Use the Up / Down buttons to select the required Mode.
When the display shows :
When the display shows :

3. Channel Mode

1) Press the Up / Down buttons, until the display shows
2) Press Enter to enter the Channel Mode. You can choose 2 different channel menus.
Use the Up / Down buttons to select the required Mode.

4. Sound control Mode

1) Press the Up / Down buttons, until the display shows
2) Press Enter to enter the Sound control Mode. The display shows
3) Turn on the music and the

5. Built-in Programs

1) Press the Up / Down buttons on the device, until the display shows
2) Press Enter to enter the Built-in Program Menu. With this menu you can set the Built-in Program Mode
of the Ignitor-6 Section Strobe. You can choose 3 built-in programs and the dimmer of each program.
Slave 1
Slave 2
the device is a slave device. It will now react the same as its master.
the device is a slave device. But it will react the opposite as its
master.
So when the master device goes right, the slave device goes left.
3 channels
8 channels
Ignitor-6 Section Strobe
Built-in Program 1
Built-in Program 2
Built-in Program 3
Dimmer 000-255
.
.
.
.
will react to the beat of the music.
12
.
.
.