Slave Mode - SHOWTEC Power Spot 9 Q6 Tour Manual

Power Spot 9 Q6 Tour
7. Built-in programs
In this menu you can you can set the built-in programs.
01) Press the MODE button until the display shows
02) Press the SETUP button to open this menu.
03) Press the UP/DOWN buttons to scroll through the 12 built-in programs.
04) Press the SETUP button to open menu
05) Press the UP/DOWN buttons to choose a color setting.
06) Press the SETUP button to change the flash frequency of every color from
does not apply for the color setting
07) When you select
programs.
08) Choose 2 different sub menus.
09) Press the SETUP button to open one of these menus or to switch between both menus.
10) Press the UP/DOWN buttons to change the speed from
11) Press the UP/DOWN buttons to change the flash frequency from

8. Slave Mode

In this menu you can set slave mode.
01) Press the MODE button and then the UP/DOWN buttons, until the display shows
If the device has not been set to slave, it is automatically classified as a master device. All slave
devices will follow the master movement. If the device has been set to slave, it will react the same as
its master device.
Ordercode: 42576
.
.
, press the UP/DOWN buttons to switch between the built-in
Speed from 000-100.
Flash Frequency from 000-099.
.
17
. This
.
.
.