Table of Contents
Advertisement
Power Spot 9 Q6 Tour
The Power Spot 9 Q6 Tour can be operated with a DMX controller in control mode or without the DMX
controller in stand-alone mode.
Control Panel
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign DMX fixture addresses, which is the first
channel with which the Power Spot will respond to the controller.
Please note, when you use the controller, the unit has 10 channels.
When using multiple Power Spots, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Power Spot should be 1(001); the DMX address of the second
Power Spot should be 1+10=11 (011); the DMX address of the third Power Spot should be 11+10=21 (021),
etc. Please, be sure that you do not have any overlapping channels in order to control each Power Spot
correctly. If two or more Power Spots are addressed similarly, they will work similarly.
Controlling:
After having addressed all Power Spot fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the Power Spot will automatically detect whether DMX 512 data is received or
not.
If there is no data received at the DMX-input, the "LED " on the control panel will not flash.
If not, the problem may be:
•
The XLR cable from the controller is not connected with the input of the Power Spot 9 Q6 Tour.
•
The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 10 seconds
When no button is pressed for 10 seconds, the display will turn off.
To light up the display, you have to press the MODE, SETUP, UP or DOWN button.
Once you have pressed the button, the display will light up.
Ordercode: 42576
A) LED display
B)
MODE button
C) SETUP button
D) UP button
E)
DOWN button
13
Fig. 05
Hide quick links:
Advertisement
Table of Contents
