Hitachi HF-W2000 Instruction Manual page 70

1.8 Power cord
When procuring an AC power cord, make sure that the cord has proper rating
and meets local safety requirements whatever applicable. Otherwise, an electric
shock or machine failure may result.
The power cord that comes with the equipment is rated at the input voltage of 125VAC.
When using this equipment at over 125VAC, prepare the power cord fitting input voltage and
inspect the safeness of this equipment enough. Common power cords are shown in Table 1-3.
1 ANSI: American National Standards Institute
2 NEMA: National Electrical Manufacture's Association
3 IEC: International Electrotechnical Commission
4 CEE: International Commission on Rules for the Approval of Electrical Equipment
5 BS: British Standard Institution
6 AS: Standards Association of Australia
7 GB:国家标准(Guójiā Biāozhǔn)
CAUTION
1-20
1. GETTING STARTED