Hitachi HF-W2000 Instruction Manual page 59

Name
AC inlet
Power supply
Audio port (LINE IN)
Audio port (LINE OUT)
Serial port (COM1)
(9 pins: RS-232C)
Serial port (COM2)
(9 pins: RS-232C)
(optional)
RAS external contact port
(25 pins: EXT)
(optional)
DVI-I port (*1)
DVI-D port
DisplayPort
PCI bus slot
PCI Express x16 bus slot
PCI Express x4 bus slot
PCI Express x1 bus slot
USB port (USB2.0/USB3.0)
(*1) By using a conversion connector or DVI-A cable, you can output an analog VGA signal. The
conversion connector or DVI-A cable must be provided by the user.
Table 1-1 Function of Each Part (2/5)
Used for connecting a power cord.
A power supply module with a wide-range input voltage (100 to 240
VAC).
An audio line input.
An audio line output.
You can use this connector to connect a device such as a modem that uses
a serial interface.
(See "5.8.1 Connector specifications".)
Connects a device such as a modem that uses a serial interface.
(See "5.8.1 Connector specifications".)
A connector for connecting external contacts. (See "5.8.1 Connector
specifications".)
Connects the cable from the digital interface of a display. (See "5.8.1
Connector specifications".)
Connects the cable from the digital interface of a display. (See "5.8.1
Connector specifications".)
Connects the cable from the digital interface of a display. (See "5.8.1
Connector specifications".)
Used as a slot to insert a PCI board.
Used as a slot to insert a PCI Express x16 board.
Used as a slot to insert a PCI Express x4 board. But the connector is a PCI
Express x16 connector.
Used as a slot to insert a PCI Express x1 board.
Used to connect a device that uses a USB interface.
1-9
1. GETTING STARTED
Function