Table 1-1 Function Of Each Part - Hitachi HF-W2000 Instruction Manual

Name
Power switch (POWER)
Reset switch (RESET)
Status lamp (STATUS)
Alarm lamp (ALARM)
Drive access lamp
(DRIVE)
Standby lamp (STBY)
HDD status lamp
HDD1 STATUS：
For drive bay 1
HDD2 STATUS：
For drive bay 2
(B model only)

Table 1-1 Function of Each Part (1/5)

When you press this switch, the power is turned on. When you press the
switch for four seconds or more, the power is turned off and the system
goes into standby mode (for emergencies only).
Use this switch to perform a hardware reset (restarting the equipment).
If you press the switch while the OS is running, a memory dump is
performed. If you press the switch again after the memory dump is
performed, a hardware reset is carried out.
Lamp
Lit in green The equipment is in operation (RUN status)
Lit in red The equipment is not in operation (STOP status)
• The equipment is in the middle of startup.
• After the shutdown starts or during error stop.
• The equipment has stopped abnormally due to an
error
• RAS software is not installed.
Off The main power is off / The system is in standby mode.
This lamp is lit in red if one of the following abnormalities is detected.
• A fan inside the equipment stops.
• Abnormal temperature inside the equipment.
• Failure in one of the mirrored disks. (B model only)
This lamp is lit in green while an HDD, SSD or DVD drive is being
accessed.
Lamp
Lit in The equipment is in standby mode. (Only the auxiliary
orange power is on.)
Off The power is shut down or the equipment is in
operation.
Lamp
Off One HDD are working properly.
Lit in red One HDD has an error. (The power of the HDD with an
error is Off.)
Flashed in Rebuild (copy) is ongoing. Only the lamp of the copy
red destination HDD flashes.
(Either one)
Flashed in Both HDDs have errors.
red (Both)
1-8
1. GETTING STARTED
Function
Status
Status
Status