Hitachi HF-W2000 Instruction Manual page 162

5. SPECIFICATION
Top
Setting item
menu
Power After AC Power On
FAN failure detection
FAN speed control
Power saving mode
Boot Boot Priority Order
Exit Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Default value
Auto
Enabled
Auto
Disabled
1. USB FDD
2. SATA CD/DVD
3. USB CD
4. DRIVE1
5. DRIVE2
6. PCI SCSI
! 7.USB HDD
8.Internal Shell
-
5-14
Note
Specifies the action when the power to the
equipment is turned on.
Stay Off: When the power is turned on, the
system goes into the soft power off
mode.
Power On: When the power is turned on, the
OS is started automatically.
Auto: If the OS was running the last time the
power was turned off, the OS starts as in
the case of Power On. If the OS was not
running the last time the power was
turned off, the system goes into the soft
power off mode as in the case of Stay
Off.
For information about the precautions to be
observed when the power from the backup
battery is not available, see "PRECAUTION
10. PRECAUTIONS ABOUT THE BIOS
SETTINGS".
Specifies whether the until will detect a fan
failure when the power is turned on.
Do not change this setting.
Set the rotational speed of the fan.
Auto: The fan speed changes automatically
according to the CPU temperature.
Full: Fan speed is always maximum.
Specifies whether to launch the CPU in the
power saving mode.
Do not change this setting.
Configures the priority order of the devices
from which an OS is booted.
Do not change this setting.
Saves the changes you made in the setup into
the SPI-ROM and reboots the system.
Discards the changes you made in the setup and
reboots the system with the configuration you
saved in the SPI-ROM last time.
Loads the BIOS default settings.
Default values are loaded but not saved in the
SPI-ROM. If you want to save the default
settings in the SPI-ROM, use "Exit Saving
Changes".
(3/3)