Implementing Frrp; Frrp Configuration - Dell S4820T Configuration Manual

Hide thumbs Also See for S4820T:
Table of Contents

Advertisement

Concept
Explanation
Ring Health-Check
The Master node generates two types of RHFs. RHFs never loop the ring because
Frame (RHF)
they terminate at the Master node's secondary port.

Implementing FRRP

FRRP is media and speed independent.
FRRP is a Dell proprietary protocol that does not interoperate with any other vendor.
You must disable the spanning tree protocol (STP) on both the Primary and Secondary interfaces
before you can enable FRRP.
All ring ports must be Layer 2 ports. This is required for both Master and Transit nodes.
A VLAN configured as a control VLAN for a ring cannot be configured as a control or member VLAN
for any other ring.
The control VLAN is not used to carry any data traffic; it carries only RHFs.
The control VLAN cannot have members that are not ring ports.
If multiple rings share one or more member VLANs, they cannot share any links between them.
Member VLANs across multiple rings are not supported in Master nodes.
Each ring has only one Master node; all others are transit nodes.

FRRP Configuration

These are the tasks to configure FRRP.
Creating the FRRP Group
Configuring the Control VLAN
– Configure Primary and Secondary ports
Configuring and Adding the Member VLANs
– Configure Primary and Secondary ports
Other FRRP related commands are:
Clearing the FRRP Counters
Viewing the FRRP Configuration
Force10 Resilient Ring Protocol (FRRP)
Hello RHF (HRHF) — These frames are processed only on the Master node's
Secondary port. The Transit nodes pass the HRHF through without processing
it. An HRHF is sent at every Hello interval.
Topology Change RHF (TCRHF) — These frames contains ring status, keepalive,
and the control and member VLAN hash. The TCRHF is processed at each node
of the ring. TCRHFs are sent out the Master Node's Primary and Secondary
interface when the ring is declared in a Failed state with the same sequence
number, on any topology change to ensure that all Transit nodes receive it.
There is no periodic transmission of TCRHFs. The TCRHFs are sent on triggered
events of ring failure or ring restoration only.
385

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents