Stacking
Stacking is supported on the S4820T platform with the Dell Networking OS version 8.3.19.0 and newer.
NOTE: The S4820T commands accept Unit ID numbers 0-11, though The S4820T supports stacking
up to six units with Dell Networking OS version 8.3.19.0.
Using the Dell Networking OS stacking feature, you can interconnect multiple S-Series switch units with
dedicated stacking ports or front end user ports. (The S50, S55, and S60 use dedicated stacking ports; the
S4820T uses front end user ports for stacking.) The stack becomes manageable as a single switch
through the stack management unit.
S-Series Stacking Overview
Dell Networking OS elects a management (master) unit, a standby unit, and all other units are member
units.
Dell Networking OS presents all of the units like line cards; for example, to access Ten GigabitEthernet
Port 1 on Stack Unit 1, enter interface tengigabitethernet 1/1 from CONFIGURATION mode.
Stack Management Roles
The stack elects the management units for the stack management.
•
Stack master — primary management unit, also called the master unit.
•
Standby — secondary management unit.
•
Stack units — the remaining units in the stack, also called stack members. The system supports up to
six stack units.
•
Stack group — Each set of four 10G ports or each individual 40G port correspond to a stack-group.
To configure the front ports on the device to be stacking-ports, use the CLI.
The master holds the control plane and the other units maintain a local copy of the forwarding databases.
From the stack master you can configure:
•
System-level features that apply to all stack members.
•
Interface-level features for each stack member.
The master synchronizes the following information with the standby unit:
•
Stack unit topology
•
Stack running configuration (which includes ACL, LACP, STP, SPAN, and so on.)
•
Logs
The master switch maintains stack operation with minimal impact in the event of:
•
Switch failure
Stacking
52
911