Configure Vlan Stacking; Creating Access And Trunk Ports - Dell S4820T Configuration Manual

Configure VLAN Stacking

Configuring VLAN-Stacking is a three-step process.
1.

Creating Access and Trunk Ports

2. Assign access and trunk ports to a VLAN
3. Enabling VLAN-Stacking for a
Related Configuration Tasks
• Configuring the Protocol Type Value for the Outer VLAN Tag
• Configuring Dell Networking OS Options for Trunk Ports
• Debugging VLAN Stacking
• VLAN Stacking in Multi-Vendor Networks
Creating Access and Trunk Ports
To create access and trunk ports, use the following commands.
• Access port — a port on the service provider edge that directly connects to the customer. An access
port may belong to only one service provider VLAN.
• Trunk port — a port on a service provider bridge that connects to another service provider bridge and
is a member of multiple service provider VLANs.
Physical ports and port-channels can be access or trunk ports.
1. Assign the role of access port to a Layer 2 port on a provider bridge that is connected to a customer.
INTERFACE mode
vlan-stack access
2. Assign the role of trunk port to a Layer 2 port on a provider bridge that is connected to another
provider bridge.
INTERFACE mode
vlan-stack trunk
3. Assign all access ports and trunk ports to service provider VLANs.
INTERFACE VLAN mode
member
Example of Displaying the VLAN-Stack Configuration for a Switchport
To display the VLAN-Stacking configuration for a switchport, use the show config command from
INTERFACE mode.
Dell#show run interface tengigabitEthernet 1/1
!
interface TenGigabitEthernet 1/1
no ip address
switchport
vlan-stack access
no shutdown
Dell#show run interface tengigabitEthernet 1/2
!
Service Provider Bridging
(Creating Access and Trunk
VLAN.
Ports).
859