Dell S4820T Configuration Manual page 301

5
6
7
Priority#
0
1
2
3
4
5
6
7
Oper status is init
Conf TLV Tx Status is disabled
Traffic Class TLV Tx Status is disabled
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Traffic Class TLV Pkts, 0 Output Traffic Class TLV Pkts, 0 Error
Traffic Class TLV
Pkts
The following table describes the show interface ets detail command fields.
Table 18.
show interface ets detail
Field
Interface
Maximum Supported TC Group
Number of Traffic Classes
Admin mode
Admin Parameters
Remote Parameters
Local Parameters
Operational status (local port)
Data Center Bridging (DCB)
0% ETS
0% ETS
0% ETS
Bandwidth TSA
13% ETS
13% ETS
13% ETS
13% ETS
12% ETS
12% ETS
12% ETS
12% ETS
Command Description
Description
Interface type with stack-unit and port number.
Maximum number of priority groups supported.
Number of 802.1p priorities currently configured.
ETS mode: on or off.
ETS configuration on local port, including priority
groups, assigned dot1p priorities, and bandwidth
allocation.
ETS configuration on remote peer port, including
Admin mode (enabled if a valid TLV was received
or disabled), priority groups, assigned dot1p
priorities, and bandwidth allocation. If the ETS
Admin mode is enabled on the remote port for
DCBx exchange, the Willing bit received in ETS
TLVs from the remote peer is included.
ETS configuration on local port, including Admin
mode (enabled when a valid TLV is received from a
peer), priority groups, assigned dot1p priorities, and
bandwidth allocation.
Port state for current operational ETS
configuration:
• Init: Local ETS configuration parameters were
exchanged with peer.
• Recommend: Remote ETS configuration
parameters were received from peer.
301