Ets Prerequisites And Restrictions - Dell S4820T Configuration Manual

priority group, use the bandwidth percentage parameter. The sum of the bandwidth allocated to all
priority groups in a DCB map must be 100% of the bandwidth on the link. You must allocate at least
1% of the total bandwidth to each priority group.
• Scheduling of priority traffic: dot1p priority traffic on the switch is scheduled to the current queue
mapping. dot1p priorities within the same queue must have the same traffic properties and scheduling
method.
• ETS configuration error: If an error occurs in an ETS configuration, the configuration is ignored and
the scheduler and bandwidth allocation settings are reset to the ETS default value: 100% of available
bandwidth is allocated to priority group 0 and the bandwidth is equally assigned to each dot1p
priority.
If an error occurs when a port receives a peer's ETS configuration, the port's configuration resets to the
ETS configuration in the previously configured DCB map. If no DCB map was previously applied, the port
resets to the default ETS parameters.

ETS Prerequisites and Restrictions

On an S6000 switch, ETS is enabled by default on Ethernet ports with equal bandwidth assigned to each
802.1p priority. You can change the default ETS configuration only by using a DCB map.
The following prerequisites and restrictions apply when you configure ETS bandwidth allocation or strict-
priority queuing in a DCB map:
• When allocating bandwidth or configuring strict-priority queuing for dot1p priorities in a priority group
on a DCBx CIN interface, take into account the CIN bandwidth allocation (see
Allocation for DCBx
• Although ETS bandwidth allocation or strict-priority queuing does not support weighted random early
detection (WRED), explicit congestion notification (ECN), rate shaping, and rate limiting because these
parameters are not negotiated by DCBx with peer devices, you can apply a QoS output policy with
WRED and/or rate shaping on a DCBx CIN-enabled interface. In this case, the WRED or rate shaping
configuration in the QoS output policy must take into account the bandwidth allocation or queue
scheduler configured in the DCB map.
Priority-Group Configuration Notes
When you configure priority groups in a DCB map:
• A priority group consists of 802.1p priority values that are grouped together for similar bandwidth
allocation and scheduling, and that share the same latency and loss requirements. All 802.1p priorities
mapped to the same queue must be in the same priority group.
• In a DCB map, each 802.1p priority must map to a priority group.
• The maximum number of priority groups supported in a DCB map on an interface is equal to the
number of data queues (4) on the port. Each priority group can support more than one data queue.
• You can enable PFC on a maximum of two priority queues on an interface.
• If you configure more than one priority group as strict priority, the higher numbered priority queue is
given preference when scheduling data traffic.
278
CIN) and dot1p-queue mapping.
Configuring Bandwidth
Data Center Bridging (DCB)