Dell S4820T Configuration Manual page 919

• before the management unit downloads its Dell Networking OS version 8.3.12.0 or later to the new
unit. The syslog includes the unit number, previous version, and version being downloaded.
• when the firmware synchronization is complete.
• if the system check fails, a message such as a hardware incompatibility message or incompatible
uboot version is generated. If the unit is placed in a card problem state, the management unit also
generates an SNMP trap.
• if the software version of the new unit predates Dell Networking OS version 8.3.12.0 , the
management unit puts the new unit into a card problem state and generates a syslog that identifies
the unit, its Dell Networking OS version, and its incompatibility for firmware synchronization.
NOTE: You must enter the stack-unit stack-unit stack-group stack-group command
when adding units to a stack to ensure the units are assigned to the correct groups.
NOTE: Any scripts used to streamline the stacking configuration process must be updated to reflect
the Command Mode change from EXEC to CONFIGURATION to allow the scripts to work correctly.
Enabling Front End Port Stacking
To enable the front ports on an S4820T unit for stacking, use the following commands.
NOTE: After a port has been allocated for stacking, you can only use it for stacking. If stack-group 0
is allocated for stacking, you can use ports 0, 1, 2, and 3 for stacking but not for Ethernet anymore.
If only port 0 is used for stacking, ports 1, 2, and 3 are spare; they cannot be used for Ethernet.
1. Assign a stack group for each unit.
CONFIGURATION mode
stack-unit id stack-group id
Begin with the first port on the management unit. Next, configure both ports on each subsequent
unit. Finally, return to the management unit and configure the last port.
The range is from 0 to 15.
2. Save the stacking configuration on the ports.
EXEC Privilege mode
write memory
3. Reload the switch.
EXEC Privilege mode
reload
Dell Networking OS automatically assigns a number to the new unit and adds it as member switch in
the stack.
The new unit synchronizes its running and startup configurations with the stack.
4. After the units are reloaded, the system reboots. The units come up in a stack after the reboot
completes.
To view the port assignments, use the show system stack-unit command.
Stacking
919