Dell S4820T Configuration Manual page 921

Example of a Syslog
Figure 120. Creating a New Stack
In the following example, stack unit is the master management unit, stack unit 2is the standby unit. The
cables are connected to each unit.
Configure the stack groups on the units in the following order:
• Configure the first stack group on unit 1: stack-unit 1 stack-group 13
• Configure the stack groups on unit 2: stack-unit 2 stack-group 14 and stack-unit 2
stack-group 15
• Configure the stack groups on unit 3: stack-unit 3 stack-group 12 and stack-unit 3
stack-group 13
• Configure the stack groups on unit 4: stack-unit 4 stack-group 13 and stack-unit 4
stack-group 31
• Configure the final stack-group on unit 1 to complete the stack: stack-unit 1 stack-group 31
When the stack-group configuration is complete, the system prints a syslog for reload.
Dell#configure
Dell(conf)#stack-unit 4 stack-group 13
Dell(conf)#02:39:12: %STKUNIT4-M:CP %IFMGR-6-STACK_PORTS_ADDED: Ports Fo 4/52
have been configured as
stacking ports. Please save and reload for config to take effect
Dell(conf)#stack-unit 4 stack-group 14
Dell(conf)#02:39:15: %STKUNIT4-M:CP %IFMGR-6-STACK_PORTS_ADDED: Ports Fo 4/56
have been configured as
stacking ports. Please save and reload for config to take effect
Dell(conf)#
Dell#02:39:18: %STKUNIT4-M:CP %SYS-5-CONFIG_I: Configured from console
Reload each unit in the stack. After the reload is complete, the four units come up as a stack with unit 1 as
the management unit, unit 2 as the standby unit, and the remaining units as stack-members. All units in
the stack can be accessed from the management unit.
To view the stack unit information after the reload, use the show system brief command.
The following example shows how to configure two new switches for stacking using 10G ports.
Dell-1(conf)#stack-unit 0 stack-group 0
Setting ports Te 1/1 Te 1/2 Te 1/3 as stack group will make their interface
Stacking
921