Implementation Information - Dell S4820T Configuration Manual

Hide thumbs Also See for S4820T:

Table of Contents

Figure 37. Client and Server Messaging

Implementation Information

The following describes DHCP implementation.

Dell Networking implements DHCP based on RFC 2131 and RFC 3046.

IP source address validation is a sub-feature of DHCP Snooping; the Dell Networking OS uses access

control lists (ACLs) internally to implement this feature and as such, you cannot apply ACLs to an

interface which has IP source address validation. If you configure IP source address validation on a

member port of a virtual local area network (VLAN) and then attempt to apply an access list to the

VLAN, Dell Networking OS displays the first line in the following message. If you first apply an ACL to a

VLAN and then attempt enable IP source address validation on one of its member ports, Dell

Networking OS displays the second line in the following message.

% Error: Vlan member has access-list configured.

% Error: Vlan has an access-list configured.

NOTE: If you enable DHCP Snooping globally and you have any configured L2 ports, any IP ACL,

MAC ACL, or DHCP source address validation ACL does not block DHCP packets.

Dell Networking OS provides 40K entries that can be divided between leased addresses and excluded

addresses. By extension, the maximum number of pools you can configure depends on the subnet

mask that you give to each pool. For example, if all pools were configured for a /24 mask, the total

would be 40000/253 (approximately 158). If the subnet is increased, more pools can be configured.

The maximum subnet that can be configured for a single pool is /17. Dell Networking OS displays an

error message for configurations that exceed the allocated memory.

This platform supports 4000 DHCP Snooping entries.

All platforms support Dynamic ARP Inspection on 16 VLANs per system. For more information, refer to

NOTE: If the DHCP server is on the top of rack (ToR) and the VLTi (ICL) is down due to a failed

link, when a VLT node is rebooted in BMP (Bare Metal Provisioning) mode, it is not able to reach

the DHCP server, resulting in BMP failure.

Dynamic Host Configuration Protocol (DHCP)