Dell S4820T Configuration Manual page 767

Honoring dot1p Values on Ingress Packets
Dell Networking OS honors dot1p values on ingress packets with the Trust dot1p feature.
The following table specifies the queue to which the classified traffic is sent based on the dot1p value.
Table 62. Default dot1p to Queue Mapping
dot1p
0
1
2
3
4
5
6
7
Table 63. Default dot1p to Queue Mapping
dot1p
0
1
2
3
4
5
6
7
The dot1p value is also honored for frames on the default VLAN. For more information, refer to
Tagged Frames on the Default
• Enable the trust dot1p feature.
POLICY-MAP-IN mode
trust dot1p
Mapping dot1p Values to Service Queues
All traffic is by default mapped to the same queue, Queue 0.
If you honor dot1p on ingress, you can create service classes based the queueing strategy in
dot1p Values on Ingress
command from CONFIGURATION mode.
• All dot1p traffic is mapped to Queue 0 unless you enable service-class dynamic dot1p on an
interface or globally.
• Layer 2 or Layer 3 service policies supersede dot1p service classes.
Quality of Service (QoS)
VLAN.
Packets. You may apply this queuing strategy globally by entering the following
Queue ID
2
0
1
3
4
5
6
7
Queue ID
0
0
0
1
2
3
3
3
Priority-
Honoring
767