Dell S4820T Configuration Manual page 85

2. Hit any key to abort the boot process. You enter uBoot immediately, the => prompt indicates
success.
(during bootup)
press any key
3. Assign the new location to the Dell Networking OS image it uses when the system reloads.
uBoot mode
=> setenv primary_boot f10boot
Boot variable (f10boot) can take the following values:
• flash0 — to boot from flash partition A.
• flash1 — to boot from flash partition B.
• tftp://server-ip/image-file-name — to boot from the network.
4. Assign an IP address to the Management Ethernet interface.
uBoot mode
=> setenv ipaddr ip_address
For example, 10.16.150.105.
=> setenv netmask mask
For example, 255.255.0.0.
5. Assign an IP address as the default gateway for the system.
uBoot mode
=> setenv gatewayip gateway_ip_address
For example, 10.16.150.254.
6. Save the modified environmental variables.
uBoot mode
=> saveenv
7. Reload the system.
uBoot mode
reset
Management
85