C-COM Satellite iNetVu 7710 User Manual page 99

C-COM Satellite Systems Inc.
Enable Beep
This drop box is used to either enable or disable the beeping noise when navigating the LCD interface on
the iNetVu ® 7710 Controller. Selected option implies beeping sound is enabled unless D (disabled) is
selected.
D –
Beep Disabled, the sound will be completely removed.
L –
Beep Enabled, a beeping sound will occur every 2 seconds.
M –
Beep Enabled, a beeping sound will occur every 1 seconds.
H –
Beep Enabled, a beeping sound will occur every 500 milliseconds.
COM Port Interface
This drop down Menu allows the user to define the functionality of the serial interface on the iNetVu
Controller. The following are the Interface options to select from:
 DEBUG - Used for internal debugging purposes.
MODEM -

NMEA_O -

 BEACON -
BAUD (bps)
The user may define the bit rate of the serial communication interface.
Restore
Resets all platforms to the manufacture's default values, and resets beam(s), and
modem parameters settings to their defaults
Save All
Sends and saves ALL parameters to the controller's memory.
Used as a communication medium if the specified modem
supports serial interface communication. To communicate with a
Modem via Console, "MODEM" must be selected from the COM
drop down menu, and the proper baud rate of the modem must
be entered as well from the BAUD drop down menu.
Used for GPS output data gathering.
Used to establish communication with the iNetVu BR300L
Beacon Receiver.
iNetVu™ 7710 Controller User Manual
.
99
® 7710