C-COM Satellite iNetVu 7710 User Manual page 50

C-COM Satellite Systems Inc.
2 – Platform Version Number
The user must select the platform version type to ensure the correct configuration parameters and
settings are referenced when operating the system. The platform version when selected will differentiate
hardware and software configuration on New Generation platforms which may affect the operation.
3 - Platform Serial Number
The user must enter the last five-digits of the platform serial number located on the iNetVu
away Platform. If platform and controller were purchased as a set, the number has been preconfigured for
you.
7.10.8.
CC
This menu allows for the configuration of the controller input settings
1
2
1 – Console Port Configuration
Used for the configuration of the console port on the 7710 Controller. The Console port could be used for
the following:
a) MDM (Modem Communication)
If the COM port is used to establish communication between the Controller and the VSAT
Modem (i.e. iDirect, Viasat, etc.), then MDM must be selected in this field, along with the
Baud Rate the Modem operates on, prior to configuring the Service, and Communication
Interface.
MDM--4800
MDM--9600
MDM--38400
b) B_R (Beacon Receiver)
The Beacon Receiver is a satellite acquisition lock controller that could be used alongside
the 7710 Controller as an option. The Beacon Receiver will lock on the Beacon
Frequency of a satellite based on the power density of the signal. If the optional Beacon
Receiver is used, B_R must be selected for the console. The default baud rate is 2400.
MDM :---9600
UN :D MP : E
Fig. 38: Console Port and Controller Features
iNetVu™ 7710 Controller User Manual
DH :D
3
BP :M
4
5
50
® Mobile or Fly-