Manual And Automatic Controls Button Operation - C-COM Satellite iNetVu 7710 User Manual

C-COM Satellite Systems Inc.
7.2.

Manual and Automatic Controls Button Operation

Fig. 8:
How to Find Satellite
Press "FIND SAT" Button.
®
iNetVu Mobile Platform will automatically attempt to locate, lock, peak and enable the system
onto the configured satellite beam or last satellite beam that locked on system. Once in the
satellite menu pressing the FIND SAT will search on the selected Satellite Beam. The LCD
keypad can also be used to maneuver to the required satellite, use the arrow keys (right or left)
to move over to the required selection and press FIND SAT will launch satellite search routine
on that selection. In order to save time and speed up the search process GPS and RF status
are ignored and movement is permitted to allow compass heading reading. If GPS and RF
conditions not met after three attempts (within 60 seconds) the search will fail and a message
will be displayed.
How to Stow the Antenna
Press "STOP/STOW" Button, and hold for 2 seconds.
iNetVu ® Mobile Platform will automatically re-center itself and lower or elevate into the stow
position. On the Fly-Away the platform will elevate into position as this is the required position
for packing the system into its storing/travel case.
How to Stop
Press "STOP/STOW" Button (do not hold). Stops all ongoing operations such as motor
movements, automatic functions like Find Satellite and Stow.
How to Manually Move the iNetVu
Press "SELECT" to select the axis of motion you wish to move. The LED corresponding to the
axes chosen will light up. Press "SPEED H/L" to select the speed (LED ON – HI, LED OFF -
LOW). Press and release "+" and "–"for short duration movement & angle readings. Press and
hold "+" and "–"for long duration movement. Warning: User must watch antenna limit sensors
(EL UP/ST, EL DN, AZ ST, AZ LP etc...) when using manual controls. See LCD 'Monitor'
section explanation for more details
How to Turn ON/OFF the Controller
Turn ON/OFF the power switch on the back panel of the iNetVu
Remote Controller does not have a power button and receives its power from the 7710.
iNetVu ® 7710 Series Controller Front Panel Buttons
® Platform
.
iNetVu™ 7710 Controller User Manual
®
7710 Controller. The 7720
21